常見問題及解決方法[2014年4月28日]在安裝時雷達液位計

A，的常識，當150度以下的流體溫度，該儀器可以是長期穩定的操作的問題；2，雷達液位計需要電源電壓的波動范圍220VAC?5%；或9-24VDC3，制造商雷達液位計液位變送器，液位變送器，電容雷達液位計電容，電容式液位變送器，電容液位變送器，是開關，電平開關，電容雷達液位計電容，電平表的電平表，電容液位變送器，電容電平發射機，RF電容電平開關，RF電容電平開關，電容電平開關，電容式液位開關，音叉式液位開關可以托管的-20℃的工作溫度范圍-+60℃；4，米和300米，以及一個距離內的傳感器之間；5，固定的功率計為15W；如圖6所示，是精密儀器？%，線性0.5%；7，該儀器可能需要測量的25mm至2540毫米管的直徑；如圖8所示，測量所述流體的濁度應小于10000ppm，且小氣泡的內容；二，問答題1，安裝儀器，為什么要接地？

①消除安全隱患，增加安全系數②③消除靜電儀器本身消除2外界干擾米的空間，當現場變頻如何解決？

①帶獨立變頻電源的功率計，以避免與不同②儀器的在房間內的驅動的干擾功率，以避免空間干擾米③電纜的良好的接地電線屏蔽必須連接④選定的輸出端口應屏蔽電纜如何檢測時好時接地3，加電無顯示儀表？

①功率儀表面板②存在或不存在所述輸入交流電壓檢測儀器的主板，電源板，以查看是否直流電壓輸出③面板打開，看插座是否就座4，如何選擇安裝點？

直管的①選擇填充有液體。

②測量點應該上游10D，下游5D被定位，沒有干擾閥。

③保證動作溫度范圍內的測量點。

④選擇管均勻且致密的，易于傳輸超聲波管部。

⑤避免泵，高功率無線電，磁場干擾，振動計的安裝位置。

如圖6所示，那些具有表輸出？

①RS232連接器②③電流回路的輸出頻率輸出7，在使用方法Z什么條件下分兩步安裝器械常用的方法V，什么樣的條件下？

①V法：適用于較小的直徑一般d<250mm②Z法：適用于較大管徑，一般D>典型地，該250mm③，V是安裝的標準方法，或當管是很厚，由于液體懸浮液的存在，嚴重結垢壁太厚或襯墊，導致V法不能正常工作，選擇的安裝方法?。

8，固定和便攜式雷達液位計具有標準？

固定①：主機，傳感器，兩根繩子，卡扣4中，兩種硅氧烷，兩個彈簧中，說明。

便攜式②：主機，充電電纜傳感器，傳感器保持器是固定的，電力線，一個適配器，兩個鋼鏈，兩個彈簧，一個描述，一卷紙。

如圖9所示，在安裝傳感器時，器械被始終檢測到的狀態，如何檢測？

①檢查參數設置是否正確；②檢查電纜而不斷裂；③檢查傳感器接線是否正確；④檢查是否在管中的流體；⑤縮放所述壁太厚或者如果襯里不緊密，重新調試切換點。

以上內容由根據從網上收集信息的制造商編制的雷達液位計知識，僅供參考，如有問題請及時溝通，指正，謝謝大家游覽。